Lamina porcelain is a type of porcelain restoration used to change the color, form and position of anterior teeth with a special bonding technique. The desired smile can be achieved in a very short time thanks to the laminates that imitate the natural teeth.
How is Laminate Veneer made?
How is Laminate Veneer made?Lamina is an aesthetic application. As with every aesthetic procedure, it gives excellent results when done with a quality material; otherwise, it will have irreparable consequences. The physician who will apply the lamina must be asked about the previous cases. If the trust is made and the decision is made; It starts with the photo shoot first. After the first measurements are taken, 3D design of the teeth is made with ceramist. In the second appointment, this 3D design (wax-up) is applied in the person’s mouth and the result is; It can be shown to the person without any operation on the teeth yet. The reason for leaving the person for a very long time in this session; so that the result is not a surprise.
The measurement session is the shortest session. On the model obtained from the measurement, thin laminates are produced as ‘hand-made’, just like a painter. Although the session after the measurement is considered as a rehearsal, finishing can also be done because the same 3D design is done. If corrections are required during the rehearsal session, the finish is made the next day. The bonding session is the most important appointment day. At the appointment after the bonding session, the treatment ends with a control and photo shoot.